Control Module: Service and Repair

Replacement
1. Disconnect the negative battery cable.
2. Remove the front side trim (passenger side).
3. Remove the Powertrain Control Module Engine.
4. Remove the Powertrain Control Module (Transmission) and disconnect the connectors.
5. Connect the Powertrain Control Module (Transmission) connectors to the new Powertrain Control Module (Transmission).
6. Install the new Powertrain Control Module (Transmission).

Tightening Torque: 7.9-1O.7 Nm (70-95 in.lb.)

7. Install the Powertrain Control Module Engine.
8. Install the front side trim (passenger side).
9. Connect the negative battery cable.