Neutral Safety Switch: Adjustments

1. Shift selector lever to N range.
2. Raise and support vehicle.
3. Remove transmission manual lever retaining nut and lever.
4. Loosen neutral switch attaching bolts and remove screw from alignment pin hole at the bottom of the switch.
5. Rotate switch and insert an alignment pin through alignment pin hole and into hole of internal rotor. The alignment pin should be approximately 0.078 inch diameter.
6. Tighten two switch attaching bolts to specifications, then remove alignment pin.
7. Reinstall alignment pin hole screw in switch body.
8. Position transmission manual lever on manual lever shaft and secure with flat washer and nut.
9. Check switch for proper operation. The engine should start only with transmission selector lever in N or P.