Ignition Control Module: Service and Repair

NOTE: Because Keep Alive Memory is erased when the battery is disconnected, some abnormal drive symptoms may occur while the Powertrain Control Module relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.

REMOVAL
1. Disconnect both battery cables, then remove the battery from the vehicle.
2. Disconnect the electrical connector from the Ignition Control Module.

View: Ignition Control Module:

3. Remove the Ignition Control Module retaining bolt and remove the module by sliding the assembly up until it is released from the teardrop shaped hole in the sheet metal.

INSTALLATION
1. Place the module on the sheet metal so the retaining rivet passes through the hole, then slide the module down into position. Install the retaining bolt bolt and torque to: 3-4 Nm (27-35 in.lb.).
2. Connect the electrical connector to the module.
3. Install the battery and cables.