Throttle Position Sensor: Adjustments

Adjustment
1. Warm up the engine to normal operating temperature and run it idle.
2. Verify that the first idle cam separates.
3. Stop the engine.




4. Connect the special service tools SSTs (Engine Signal Monitor and Adapter Harness) to the powertrain control module engine (PCME) as shown.
5. Turn the ignition switch to ON.




6. Loosen the screws and rotate the throttle position sensor to set the correct closed position voltage.




Specifications

7. Check the correct open position voltage and close to open voltage.
(Refer to "Specifications" above)
9. Tighten the screws.

Tightening Torque: 1.6-2.4 Nm (14-21 in.lb.)

10. Cancel the memory of malfunctions by disconnecting the negative battery cable for at least 20 seconds and depress the brake pedal.
11. Reconnect the negative battery cable.