Transmission Position Sensor/Switch: Service and Repair
ReplacementRefer to "Adjustment" below, for replacement of the transmission range switch.
Adjustment
1. Remove the selector rod from the manual shaft lever.
2. Move the manual shaft to N range position.
3. Loosen the transmission range switch mounting bolts.
4. Align the holes of the transmission range switch and the manual shaft lever by inserting an approx. 4.0 mm (0.157 in.) outer diameter pin.
5. Tighten the transmission range switch mounting bolts and remove the pin.
Tightening Torque: 2.5-3.9 Nm (22-34 in.lb.)
6. Recheck the continuity of the transmission range switch.
7. If not correct, replace the transmission range switch.
8. Install the selector rod to the manual shaft lever.