Transmission Position Sensor/Switch: Service and Repair
REPLACEMENT1. Remove the outer manual control lever end nut.
2. Disconnect the TR sensor from the wiring harness.
3. Remove the three TR bolts and the TR sensor.
4. Install a new TR sensor on the manual lever. Finger tighten the bolts.
5. Position the selector lever to N.
6. Rotate the manual lever to the neutral position.
Note: Use 49-UNO1-086 instead of T93P-7OO1O-A.
7. Install TR Sensor Alignment Tool T93P-70010-A or equivalent to align the three slots in line on the TR sensor.
Note:
^ The tool will have to be inserted into two slots, then rotated to the third.
^ The manual lever must be in the neutral position.
8. Tighten the bolts
Tightening torque: 8-11 N-m (71-97 in-lb)
9. Install the outer manual control lever and nut.
Tightening torque: 41-54 N-m (30-40 ft-lb)