Reassembly

REASSEMBLY
Standard values, such as tightening torques and adjustment values must be strictly observed in the reassembly of all parts.

If removed, these parts should be replaced with new ones:
1. Oil seals
2. Gaskets
3. O-rings
4. Lock washers
5. Cotter pins
6. Nylon nuts





Depending on location:
1. Sealant gasket, or both should be applied to the specified location. When sealant is applied, parts should be installed before sealant hardens. Hardened sealant causes leaks.
2. Oil should be applied to the sliding surfaces of moving parts.
3. Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.