Transmission Position Sensor/Switch: Adjustments

Adjustment
1. Remove the selector rod from the manual shaft lever.




2. Move the manual shaft to N position.
3. Loosen the transmission range switch mounting bolts.
4. Align the holes of the transmission range switch and the manual shaft by inserting a 4.0 mm (0.16 in) outer diameter pin.




5. Tighten the transmission range switch mounting bolts and remove the pin.

Tightening Torque: 2.5-3.9 N m (22-34 in.lb.)

6. Recheck the continuity of the transmission range switch.
7. If not correct, readjust or replace the transmission range switch.
8. Install the selector rod to the manual shaft lever.