Throttle Position Sensor: Service and Repair

REMOVAL / INSTALLATION
1. Disconnect the throttle position sensor connector.
2. Remove the throttle position sensor screws.
3. Remove the throttle position sensor.

CAUTION:
^ Slide rotary tangs into position over throttle shaft blade, then rotate throttle position sensor clockwise only to install position.
^ Failure to install throttle position sensor in this manner may result in excessive idle speeds.

NOTE: The throttle position sensor is not adjustable.

4. Install in the reverse order of removal.

Tightening torque 3-4 Nm (27-35 in. lbs.)