With Manual Transaxle

REMOVAL / INSPECTION / INSTALLATION
1. Remove in the order shown in the figure.
2. Inspect the intake-air system components and repair or replace them as necessary.
3. Install in the reverse order of removal.

Intake Components:

1. Fresh-air duct
2. Air cleaner
3. Air cleaner element
4. Mass air flow sensor
5. Air hose
6. Resonance chamber
7. Accelerator cable
8. Throttle body
9. BAC valve
10. Fuel distributor
11. Intake manifold bracket
12. Intake manifold

Clamp Location On Resonance Chamber:

Intake Air Hose, Holddown:

Clamp Location On Resonance Chamber:

RESONANCE CHAMBER INSTALLATION NOTE
1. Slide the hose clamp onto the hose and push it onto the resonance chamber.
2. Rotate the hose and hook it securely onto the locating knob.
3. Tighten the hose clamp.

Intake Manifold Torque Sequence:

INTAKE MANIFOLD INSTALLATION NOTE
1. Tighten the bolts in the order shown in the figure.

Tightening torque: 19-25 Nm (1.9-2.6 kgf/m., 14-18 ft.lbs.)

2. Refill the radiator with the specified engine coolant.
3. Check for engine coolant leakage.