With Manual Transaxle

Camshaft Position Sensor Installation:

REPLACEMENT
1. Remove the undercover.
2. Remove bolt (A).
3. Remove bolt (B) and bracket.
4. Install in the reverse order of removal.

Tightening torque (bolts A & B): 7.9-10.7 Nm (70-95.4 in.lbs.)

5. Adjust the air gap.

Camshaft Position Sensor Installation:

ADJUSTMENT
1. Loosen the bolt (A).

Crankshaft Position Sensor Air Gap:

2. Adjust the air gap between the crankshaft pulley projection and the crankshaft position sensor by using a feeler gauge.

Specification: 0.5-1.5 mm (0.020-0.059 in.)

3. If not adjusted, replace the bracket and readjust the air gap.
4. If not adjusted, replace the crankshaft pulley or the crankshaft position sensor.