With Manual Transaxle

Crankshaft Position Sensor Connector:

INSPECTION
1. Disconnect the crankshaft position sensor connector.
2. Measure the resistance between terminals A and B by using an ohmmeter.

Specification: 520-580 Ohms 20°C (68°F)

3. If not as specified, replace the crankshaft position sensor.

Crankshaft Position Sensor Air Gap:

4. Measure the air gap between the crankshaft pulley projection and the crankshaft position sensor by using a feeler gauge.

Specification: 0.5-1.5 mm (0.020-0.059 in.)

5. If not as specified, adjust the air gap.

Camshaft Position Sensor Installation:

ADJUSTMENT
1. Loosen the bolt (A).

Crankshaft Position Sensor Air Gap:

2. Adjust the air gap between the crankshaft pulley projection and the crankshaft position sensor by using a feeler gauge.

Specification: 0.5-1.5 mm (0.020-0.059 in.)

3. If not adjusted, replace the bracket and readjust the air gap.
4. If not adjusted, replace the crankshaft pulley or the crankshaft position sensor.