Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 1997 >> 626 DX L4-2.0L DOHC >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Distributor >> Service and Repair >> Removal and Installation >> With Automatic Transaxle (ATX)
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

With Automatic Transaxle (ATX)

REMOVAL / INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct.

Distributor R & R FS (ATX):




3. Remove in the order shown in the figure.
4. Install in the reverse order of removal, referring to Installation Note.

INSTALLATION NOTE

Installation Note FS:




1. Verify that the No.1 cylinder is at top dead center and the distributor matching marks are aligned.
2. Install the distributor and connect the high-tension leads and distributor connector.
3. Tighten the locknut or bolts to the specified torque.

Tightening torque: 19-25 Nm (14-18 ft.lbs.)


pro multis · About Operation CHARM