With Manual Transaxle

Distributor Removal:

Inspection
1. Remove the distributor.
2. Disconnect the fuel injector connector.
3. Connect the distributor 6-pin connector.

WARNING:
- Turning the ignition switch to ON with the fuel injector connector still connected will actuate the fuel injector.
- Turning the ignition switch to ON with the distributor 3-pin connector still connected will generate sparks, which can cause electrical shock. Disconnect the connector and avoid it from grounding to the vehicle body.

Special Service Tool (Engine Signal Monitor):

4. Connect the Special Service Tool (SST) to the Powertrain Control Module (PCM).
5. Turn the ignition switch to ON.

Triggering The Camshaft Position Sensor:

6. Rotate the distributor drive by hand and check the output signal.
7. Measure the voltage at PCM terminals 4F and 4G.

Camshaft Position Sensor Specifications:

8. If not as specified, inspect the wiring harness and connector between the distributor and the PCM terminal.
9. If there is correct terminal voltage and harness continuity, replace the distributor.