With Manual Transaxle

TPS Connector:

INSPECTION OF RESISTANCE
1. Disconnect the throttle position sensor connector.
2. Using an ohmmeter, measure the resistance between throttle position sensor terminals A and C.

Resistance: 4-6 k/Ohms

3. If not as specified, replace the throttle position sensor.
4. Reconnect the throttle position sensor connector.

INSPECTION OF OUTPUT VOLTAGE
Using the Special Service Tool (Engine signal monitor).

Special Service Tool (Engine Signal Monitor):

1. Connect the SST to the Powertrain Control Module (PCM) as shown.
2. Turn ignition switch to ON.

Throttle Position Sensor Specifications:

3. Measure voltage at PCM terminal 3F under these conditions.
(The voltage increase is linear according to the throttle valve opening angle)

4. Disconnect the SSTs.
5. If not as specified, adjust the throttle position sensor.

Using the SST (NGS)

Special Service Tool New Generation Star Tester Connected to Data Link Connector 2:

1. Connect the SSTs to the data link connector 2.
2. Select the "PID/DATA MONITOR AND RECORD" function of the New Generation Star (NGS) tester.
3. Select "TP V" on the SST display.
4. Measure the TPS output voltage under the following conditions.

Throttle Position Sensor Specifications:

(The voltage increase is linear according to the throttle valve opening angle)

5. Disconnect the SSTs.
6. If not as specified, adjust the throttle position sensor.