1998-2002 626

1998-2002 626

1. Dry the evaporator using the following procedure:

WARNING:
Running the engine inside an enclosed area, such as a garage, is dangerous. Exhaust gas, which contains poisonous carbon monoxide, could easily enter the cabin. Loss of consciousness or even death could occur. Don't run the engine when inside an enclosed area.

A. Start the engine.





B. Set the HVAC controls as follows:

^ RECIRCULATE

^ FULL HEAT

^ FAN HIGH

^ A/C OFF

^ AIRFLOW (FACE)

C. Open one window approximately one half inch.

D. Let the engine run for 15 minutes.

2. Remove the glove box by:





A. Pushing the top stops inward (plastic will flex).

B. At the right side hinge, lift the clip out of its seat.

C. Pull the left side axle pin out towards the right side and remove the glove box.

3. Shake a bottle of the Mazda Air Cooling Coil Coating well and attach it to applicator, then connect the applicator to compressed shop air.





4. Insert the applicator in the grille of the recirculation door. Point the nozzle tip downwards (approximately at the 7 o'clock position) and towards the center of the cooling unit.

5. Spray the entire contents of the bottle in short bursts, 3 seconds ON, 3 seconds OFF into the rotating fan. A fine mist may exit from the ducts.





6. When the bottle is empty, stop the engine and remove the applicator.

NOTE:
For reuse, clean the applicator by flushing a bottle of clean water through it.

7. Use STEP 1 to dry and cure the product.

8. While product is drying, re-install the glove box.

9. Note application date in service record.