System Specifications

GENERAL SPECIFICATIONS
Transmission 5-Speed
Clutch Control Hydraulic
Clutch Pedal Type Suspended
Flywheel Maximum Runout 0.2 mm (0.008 inch)
Clutch Disc Lining Depth 0.3 mm (0.012 inch)Minimum
Clutch Disc Runout 0.7 mm (0.0267 inch)Maximum
Tension Spring Adjustment 14.0 mm (0.55 inch)Maximum
System Adjustment-Clutch Automatic
Clutch Fluid SAE J1703, FMUSS116 DOT-3
Output shaft Maximum Runout 0.05 mm (0.002 inch)
Shift Fork To Synchronizer Sleeve 0.8 mm (0.031 inch)
Synchronizer Blocking ring To Gear 1.5 mm (0.059 inch)
Third/Fourth Clutch Hub End Play 0.00-0.05 mm (0.00-0.0019 inch)
Reverse Idler Gear End Play 0.1-0.2 mm (0.0039-0.0078 inch)
Fifth/Reverse Hub End Play 0.00-0.05 mm (0.00-0.0019 inch)
Countershaft Reverse Gear End Play 0.25-0.35 mm (0.0098-0.0137 inch)

Lubricant
Automatic Transmission Fluid MERCON(R) IV or M-III

MANUAL TRANSMISSION SPECIFICATIONS
Gear Ratio To 1:
1st 3.72
2nd 2.20
3rd 1.50
4th 1.00
5th(OD) 0.79
Reverse 3.40
Lubricant Capacity 5.6 pints.
Synchronizers 1,2,3,4,5 gears
Gears Carburized Steel Material
Type 1st, 2nd, 3rd, 4th, 5th & Reverse Helical
Bearings:
Main Shaft
Front Single Row Taper
Center Single row Taper
Rear Single Row Ball
Countershaft Gear
Front Single Row Roller
Center Single Row Roller
Rear Single Row Ball
Reverse Idler Gear
Type Single Row Roller