Cylinder Head Assembly
| Cylinder Head | Sequences | Removal |
| Installation | ||
| (First Pass) Tighten To | 23.1-25.9 Newton Meter (Nm) | |
| (Second Pass) Retighten | 85-95 Degrees | |
| (Third Pass) Retighten Again | 85-95 Degrees | |
| Front Camshaft Bearing Caps | Sequence | Removal Bolt No.5 in the figure fits only the right cylinder head. |
| Camshaft Bearing Caps | Sequence | Removal Remove the thrust caps only after removing all camshaft caps. Otherwise, the thrust caps can be damaged. The front camshaft bearing caps must be removed first, otherwise damage to the camshaft will occur. |
| Installation Install the thrust caps (5 mark on RH, B mark on LH) first. Otherwise, camshaft can be broken or damaged. | ||
| Camshaft Bearing Thrust Caps | Sequence | Installation |
| Camshaft Bearing Caps (All) | (First Pass) Tighten To | 11.3-14.2 Newton Meter (Nm) |
| (Second Pass) Retighten To | 11.3-14.2 Newton Meter (Nm) | |
| Camshaft Pulley | Tighten To | 123-132 Newton Meter (Nm) |
| Cylinder Head Bolt Length | Standard | 131.2 - 131.8 mm |
| Maximum | 132.5 mm |