Programming and Relearning

1. Install new PCM.
2. Using NGS Tester, perform Security Access Procedure. Refer to KEY PROGRAMMING SECURITY ACCESS PROCEDURE.
3. Select PARAMETER RESET.

NOTE: Selecting PARAMETER RESET causes PCM_ID PID to change from STORED to notSTORED.

4. After process has been completed, Key OFF.
5. Disconnect NGS Tester.

NOTE: Once initialized, the THEFT indicator should prove-out for three seconds and the vehicle will start.

6. To initialize, PCM/PATS, cycle ignition key from OFF to ON three times, each time leaving in ON for three seconds.