Cylinder Head Assembly
| Cylinder Head | Sequences | Removal | RH Cylinder Head |
| LH Cylinder Head | |||
| Installation | RH Cylinder Head | ||
| LH Cylinder Head | |||
| Tightening Torque | First Pass | Tighten to 37-43 | |
| Second Pass | Tighten 85-95 Degrees | ||
| Third Pass | Loosen 360 Degrees | ||
| Fourth Pass | Tighten to 37-43 | ||
| Fifth Pass | Tighten 85-95 Degrees | ||
| Sixth Pass | Tighten 85-95 Degrees | ||
| Camshaft Bearing Thrust Cap | Sequence | Removal | RH Cylinder Head Remove the camshaft bearing thrust caps Nos. 1R and 5R first. Do not loosen any of the other bolts until the thrust caps are removed, or damage to the thrust caps may occur. |
| LH Cylinder Head Remove the camshaft bearing thrust caps Nos. 1L and 5L first. Do not loosen any of the other bolts until the thrust caps are removed, or damage to the thrust caps may occur. | |||
| Camshaft Bearing Cap | Sequence | Removal | RH Cylinder Head |
| LH Cylinder Head | |||
| Camshaft Bearing Cap (All) | Installation | RH Cylinder Head | |
| LH Cylinder Head | |||
| Tightening Torque | 8-12 |