Power Door Lock Control Module: Testing and Inspection

1. Remove the door lock control module from its support bracket.
2. Disconnect the door lock control module connector.

Unlock All Door Types:

Unlock Only Driver's Side Type:

3. Inspect for continuity between the terminals of the door lock control module connector.
4. Reconnect the door lock control module connector.

Unlock All Door Types:

Unlock Only Driver's Side Type:

Unlock All Door Types:

Unlock Only Drivers Side Type:

5. Measure the voltage at the terminals of the door lock control module connector with the following terminals connected to GND.
- If not as specified, replace the door lock control module.