Using SST (WDS or Equivalent)

Using the ST (WDS or equivalent Tester or WDS)




1. In the passenger compartment, connect the ST to the data link connector.

CAUTION: The "PID/DATA MONITOR AND RECORD" function is to monitor the the calculation value of the input/output signals in the PCM. Deviation in the value does not always indicate malfunction in the related devices. For inspection of the input/output signals other than in the link monitor table, check voltage at the applicable PCM terminal by using the ST (104 Pin Breakout Box).

2. Carry out inspection referring to PID/DATA MONITOR table.
3. If normal output signal cannot be detected when all input signals are normal, replace the PCM.

PID/Data Monitor Item Table 1:

PID/Data Monitor Item Table 2:

PID/Data Monitor Item Table 3:

PID/DATA MONITOR ITEM TABLE

NOTE: The PIDs shown may display on the WDS or equivalent tester, but they are not used for inspection, because the devices are not applied for in this model.

PID/Data Monitor Reference Value (2.3L A/T):

PID/Data Monitor Reference Value (2.3L M/T):

PID/Data Monitor Reference Value (3.0L Flexible Fuel A/T) - Part 1:

PID/Data Monitor Reference Value (3.0L Flexible Fuel A/T) - Part 2:

PID/Data Monitor Reference Value (3.0L Flexible Fuel M/T):

PID/Data Monitor Reference Value (3.0L Gasoline A/T) - Part 1:

PID/Data Monitor Reference Value (3.0L Gasoline A/T) - Part 2:

PID/Data Monitor Reference Value (3.0L Gasoline M/T):

PID/Data Monitor Reference Value (4.0L A/T):

PID/Data Monitor Reference Value (4.0L M/T):

PID/DATA MONITOR Reference Value

Freeze Frame Charts:

FREEZE FRAME CHARTS