Component Tests and General Diagnostics

THEFT-DETERRENT CONTROL MODULE INSPECTION

1. Remove the bracket without disconnecting the connectors.
2. Measure the voltage at the theft-deterrent control module terminals as indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting for continuity at terminals 1F, 2K, 2M, 2N, and 2R.
- If not as specified, inspect the parts listed under "Action."
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the theft-deterrent control module.

Terminal Pinouts:

Terminal 1A - 2J:

Terminal 2K - 2T:

Terminal Voltage Table (Reference)