Transmission Position Sensor/Switch: Adjustments

TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT





1. Remove the spring and disconnect the selector cable.

Note:
^ Do not reuse the clip when any of the hooks are deformed.





2. Press the hooks of the clips, and remove the selector cable and clips together from the bracket as shown.





3. Rotate the manual shaft to the rear side of the vehicle fully, then return two notches to set the N position.
4. Disconnect the TR switch connector.
5. Loosen the TR switch mounting bolts.





6. Connect an ohmmeter between terminals A and H.
7. Adjust the switch to the point where there is continuity between the terminals.
8. Tighten the TR switch mounting bolts.
Tightening torque 7.8 - 11.0 Nm (79 - 113 kgf cm, 68.6 - 98.0 inch lbs.)
9. Verify that the selector lever range position and TR switch are aligned.
10. Connect the TR switch connector.
11. Connect the selector cable and install a spring and clip.