Knock Sensor: Testing and Inspection
NOTE: Perform the following test only when directed.Resistance Inspection
1. Turn the ignition switch to LOCK.
2. Disconnect the knock sensor connector.
3. Measure the resistance between the knock sensor terminals A and B.
- If not as specified, replace the knock sensor.
- If the knock sensor is okay, but PID value or PCM terminal 57 and 66 voltage are out of specification, perform the "Circuit Open/Short Inspection".
Specification
Approx. 560 kohms (20 °C {68 °F})
Circuit Open/short Inspection
1. Disconnect the PCM connector.
2. Connect the SST (104 Pin Breakout Box) with the PCM disconnected.
3. Tighten the connector attaching bolt.
Tightening torque
3.0 - 5.4 N.m {30 - 56 kgf-cm, 27 - 48 in.lbf}
4. Inspect the following wiring harness for open or short (Continuity check).
Open circuit
- If there is no continuity, the circuit is open. Repair or replace the harness.
- Knock sensor terminal A (harness-side) and 104 pin breakout box terminal 85
- Knock sensor terminal B (harness-side) and 104 pin breakout box terminal 86
Short circuit
- If there is continuity, the circuit is shorted. Repair or replace the harness.
- Knock sensor terminal A (harness-side) and power supply
- Knock sensor terminal A (harness-side) and body ground
- Knock sensor terminal B (harness-side) and power supply
- Knock sensor terminal B (harness-side) and body ground