After Repair Procedure

WARNING: Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. When installing the fuel hose, observe "Fuel Hose Installation" and "Fuel Leakage inspection" described below.

Fuel Hose Installation

1. Replace damaged or deformed fuel hoses, fuel pipes, and/or hose clamps.




2. When installing the fuel hose onto the fuel pipe, fit the hose onto the pipe over 25 mm {1.0 in}.
3. When the pipe has a stopper, fit the hose until it contacts the stopper.




4. Install a hose clamp over the fuel hose within the clamp installation range as shown, avoiding the original clamp position.

Fuel Leakage Inspection

WARNING: Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Always carry out the following procedure with the engine stopped.




1. Short DLC terminal F/P to body GND using a jumper wire.

CAUTION: Connecting the wrong DLC terminal may possible cause a malfunction. Carefully connect the specified terminal only.

2. Turn the ignition switch on to operate the fuel pump.

3. Pressurize the system this way for at least 5 min to be sure of no leakage.
- If there is fuel leakage, inspect for damaged fuel hoses, hose clamps, and fuel pipe sealing surface and replace as necessary.

4. After repair, assemble the system and repeat Steps 1 to 3.