Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2001 >> Protege ES L4-2.0L DOHC >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Transmission Position Sensor/Switch >> Adjustments
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Transmission Position Sensor/Switch: Adjustments

TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct and air cleaner component.
3. Remove the splash shield.





4. Remove the clip and disconnect the selector cable.





5. Rotate the manual shaft to the converter housing side fully, then return 2 notches to set the N position.





6. Disconnect the TR switch connector.





7. Loosen the TR switch mounting bolts.





8. Connect an ohmmeter between terminals B and H.
9. Adjust the switch to the point where there is continuity between the terminals.
10. Tighten the TR switch mounting bolts.
Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 69.5 - 95.4 inch lbs.)
11. Verify that the selector lever range position and TR switch are aligned.
12. Connect the TR switch connector.





13. Install the clip as shown in the figure.





14. Connect the selector cable.
15. Install the splash shield.
16. Install the air cleaner component and fresh-air duct.
17. Connect the negative battery cable.

pro multis · About Operation CHARM