Information

(All 2001 Model and early 2002 Model with PCM tear tag of "SJC0, SJC1, or SJC2", 2002 Model with PCM tear tag of HQP1, HQP2, HQP3, or RKG0, and 2003 Model with PCM tear tag BAR0 or BAR1)

NOTE:
^ WDS shows the calibration part number after programming the PCM.

^ Please be aware that PCM calibration part numbers and file names listed in any Service Bulletin may change due to future releases of WDS software and additional revisions made to those calibrations for service related concerns. When reprogramming a PCM, WDS will always display the "latest" calibration P/N available for that vehicle. If any calibration has been revised/updated to contain new information for a new service concern/issue, it will also contain all previously released calibrations.

Connect WDS to the vehicle and perform the below PCM calibration re-flash procedure. Please pay special attention to the following Vehicle PCM information BEFORE beginning this procedure:

- If vehicle PCM tear tag # is JYB2, JYB3 (MPC-160 level) you must first replace PCM with a later style PCM with Tear Tag # of SJC0, SJC1, SJC2, or SJA3 (MPC-161 level) by performing the PROGRAMMABLE MODULE INSTALLATION (PMI) PROCEDURE (See Procedure 1).

- If vehicle PCM tear tag # is SJC0, SJC1, SJC2, HQP1, HQP2, HQP3, RKB0, BAR0, or BAR1 use WDS B21.5 or later and re-flash PCM by performing the "module reprogramming" procedure. (See Procedure 2)

The latest calibration PCM P/N for tear tag SJC0, SJC1, or SJC2 is 1U7A-12A650-AYD. File name is DOAR63W.

If vehicle PCM tear tag is HQP1, HQP2, HQP3, or RKG0, the latest calibration PCM P/N is 2U7A-12A650CRB. File name is DOAR63Y

If vehicle PCM tear tag is BAR0 or BAR1, the latest calibration PCM P/N is 3L8A-12A650-BC. File name is D0AV535.