Hold Switch Removal/Installation

HOLD SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rear console, brake boot panel, and center panel.
3. Remove the indicator panel installation screws.
4. Disconnect the connector and remove the HOLD switch terminals.
5. Remove the selector lever knob component.
6. Install a new selector lever knob component.
Tightening torque 2.0 - 2.9 Nm (20 - 30 kgf-cm, 18 - 26 inch lbs.)
7. Install the HOLD switch terminals and connect the connector.
8. Install the indicator panel installation screws.
9. Install the center panel, brake boot panel, and rear console.
10. Connect the negative battery cable.