Component Tests and General Diagnostics

KEYLESS CONTROL MODULE INSPECTION

1. Pull out the keyless control module with the connector connected.

Terminal Voltage List/Pinouts Part 1:

Pinouts Part 2:

2. Measure the voltage at the keyless control module terminals (other than terminal L) as indicated.
- If not as specified, inspect the parts listed under "Action."

3. Disconnect the negative battery cable.
4. Disconnect the keyless control module connector and inspect for continuity between terminal L and bracket.
5. Inspect for continuity at terminal L as indicated below.
6. If the parts and wiring harnesses are okay but the system still does not work properly, perform the troubleshooting.