B1935

Pinpoint Test 15: LFC 35/DTC B1935 - PASSENGER AIR BAG CIRCUIT RESISTANCE LOW

Normal Operation
The restraints control module (RCM) monitors the resistance of the passenger air bag ignitor by measuring the resistance between pins 6 and 7. If the RCM detects low resistance between these pins, it will store a diagnostic trouble code (DTC) B1935 in memory and flash a lamp fault code (LFC) 35 (or higher priority code if one exists) on the air bag indicator.

Possible Causes
Passenger air bag low resistance can be caused by:
- a short in the wiring harness.
- a low resistance in the passenger air bag module.
- an RCM internal concern.
- a worn or damaged shorting bar.
- a worn or damaged connector camming beam (component side).

WARNING: If the supplemental restraint system (SRS) is being serviced, the system must be deactivated and restraint system diagnostic tools must be installed.

The air bag restraint system diagnostic tools must be removed and the air bag modules reconnected when the system is reactivated to avoid non-deployment in a collision, resulting in possible personal injury.

NOTE: Diagnostics or repairs are not to be performed on a seat equipped with a seat side air bag with the seat in the vehicle. Prior to attempting to diagnose or repair a seat concern when equipped with a seat side air bag, the seat must be removed from the vehicle and the restraint system diagnostic tools must be installed in the seat side air bag electrical connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.

NOTE: After diagnosing or repairing an SRS, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

NOTE: After diagnosing or repairing a seat system, the restraint system diagnostic tools must be removed before operating the vehicle over the road.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

Step 1 - 2:

Step 3 - 4:

Step 5: