Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2003 >> Tribute 2WD L4-2.0L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Accessories and Optional Equipment >> General Module >> Service and Repair >> Removal and Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Removal and Installation

GENERIC ELECTRONIC MODULE (GEM)

Removal and Installation

NOTE: Prior to removal of the GEM, it is necessary to upload module configuration information to a WDS or equivalent Tester. This information needs to be downloaded into the new module once installed. For additional information, refer to GENERIC ELECTRONIC MODULE (GEM) PROGRAMMING - NGS or GENERIC ELECTRONIC MODULE (GEM) PROGRAMMING - WDS.

1. Disconnect the battery ground cable. For additional information, refer to BATTERY DISCONNECT.




2. Remove the pin-type retainer and the lower shield.




3. Position the LH and RH carpet aside from the center tunnel.




4. Disconnect the GEM electrical connectors.




5. Remove the GEM
1. Pull back the insulation and remove the nuts.
2. Remove the GEM.

CAUTION: Once the new GEM is installed, it is necessary to download the module configuration information from the scan tool into the new GEM. You must also configure the new GEM for dealer-installed optioned. Please refer to applicable accessory installation procedures. For additional information; refer to MODULE CONFIGURATION.

6. To install, reverse the removal procedure.
- Configure the GEM. Refer to GENERIC ELECTRONIC MODULE (GEM) PROGRAMMING - NGS or GENERIC ELECTRONIC MODULE (GEM) PROGRAMMING - WDS.

pro multis · About Operation CHARM