Crankshaft Pulley Lock Bolt Assembly Note

Crankshaft Pulley Lock Bolt Assembly Note





1. Install the SST to the camshaft as shown in the figure.





2. Install the M6 x 1.0 bolt in by hand.
3. Turn the crankshaft clockwise so that the crankshaft is in the No.1 cylinder TDC position.





4. Hold the crankshaft pulley using the SST.
5. Tighten the crankshaft pulley lock bolt in the order shown following two steps using the SST (49 D032 316).
Tightening torque
(1) 96-104 N-m (9.8-10.6 kgf-m, 70.9-76.7 ft-lbf)
(2) 87°-93°
6. Remove the M6 x 1.0 bolt.
7. Remove the SST from the camshaft.
8. Remove the SST from the block lower blind plug.
9. Rotate the crankshaft clockwise two turns until the TDC position.
^ If not aligned, loosen the crankshaft pulley lock bolt and repeat from Step 1.
10. Install the cylinder block lower blind plug.
Tightening torque 18-22 N-m (1.9-2.2 kgf-m, 13.3-16.2 ft-lbf)