Rear Washer Hose
REAR WASHER HOSE REMOVAL/INSTALLATION1. Disconnect the negative battery cable.
2. Slightly bend back the mudguard (RH).
3. Disconnect the rear washer hose A from the washer tank.
4. Remove rear washer hose A from clips A.
5. Remove A-pillar trim (RH).
6. Remove the glove compartment.
7. Remove the dashboard garnish.
8. Disconnect joint pipe, then remove the rear washer hose A.
9. Remove rear washer hose B from the clips B.
10. Remove the following parts:
1. Upper anchor of the front seat belt
2. Front scuff plate
3. Rear scuff plate
4. B-pillar lower trim
5. B-pillar upper trim
6. Rear seat
7. Tire house trim
8. Trunk side upper trim
9. C-pillar trim
10. Map light
11. Sunvisor
12. Assist handle
11. Disconnect the joint pipe B.
12. Remove the headliner.
13. Remove rear washer hose B and the tapes.
14. Remove clips C from the body.
15. Disconnect the joint pipe C, then remove rear washer hose C.
16. Remove rear washer hose D from the rear washer nozzle.
17. Install in the reverse order of removal.