Body Misalignment Inspection

BODY MISALIGNMENT INSPECTION

CAUTION: Do not attempt to correct a serious misalignment with one jacking operation. Align each section proportionately until the proper dimensions are obtained.

NOTE: To ensure accurate measurements, remove all trim from the reference points to expose bare metal.

1. To align or square a body, take two opposite diagonal measurements between pillars. Take measurements between reference points such as crease lines or weld joints that are diagonally opposite each other on the two pillars being measured.
2. When repairing a vehicle with damage on both sides, take horizontal and verbcal measurements from a B-Series of the same body style and transfer the dimensions to the damaged vehicle. Alignment can be made by diagonal measurements taken from points on the two pillars.

NOTE: On a known level surface, verify that the vehicle ride height is within specifications before proceeding with the frame height measurements.

1. The dimensions of the underbody must be restored if repairing major body damage to provide correct front and rear wheel geometry. Once the frame and suspension members are aligned, other operations can be performed.