Transmission Position Sensor/Switch: Service and Repair

DIGITAL TRANSMISSION RANGE SENSOR REMOVAL / INSTALLATION

Removal Note

Note:
^ When the battery has been disconnected and reconnected, some abnormal drive symptoms can occur while the vehicle relearns its adaptive strategy. The customer needs to be notified that they may experience slightly different upshifts either soft or firm and this is a temporary condition and will eventually return to normal operating condition.

1. Disconnect the, negative battery cable.
2. Raise and support the vehicle.





3. Disconnect the shift cable from the manual control outer lever.





4. Disconnect the digital transmission range (TR) sensor electrical connector.





5. Remove the manual control outer lever nut and manual control outer lever.





6. Remove the bolts and the digital TR sensor.

Installation Note





1. Install the digital TR sensor.
1 Position the digital TR sensor.
2 Loosely install the bolts.

Note:
^ The manual lever must be in neutral.





2. Adjust the digital TR sensor.
1 Install SST into the three slots on the digital TR sensor.
2 Tighten the bolts.





3. Install the manual control outer lever.
1 Install the manual control outer lever.
2 Install the manual control outer lever nut.





4. Connect the TR sensor electrical connector.





5. Connect the shift cable to the manual control outer lever.
6. Adjust the shift cable.
7. Lower the vehicle.

Note:
^ When the battery has been disconnected and reconnected, some abnormal drive symptoms can occur while the vehicle relearns its adaptive strategy, The customer needs to be notified that they may experience slightly different upshifts either soft or firm and this is a temporary condition and will eventually return to normal operating condition.

8. Connect the negative battery cable.