Electronic Brake Control Module: Service and Repair

ABS HU/CM REMOVAL/INSTALLATION





Caution:
^ Do not drop the ABS HU/CM. Replace it if it is subjected to an impact.

1. Remove the battery
2. Remove the air cleaner.
3. Remove the air filter.
4. Remove the splash shield.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.

Connector Removal Note





1. Pull the lock lever up and make it unlock.
2. Remove the connector.

Brake Pipe Removal Note





1. Mark the brake pipe connecting positions before removal for reference during installation.

ABS HU/CM Removal/installation Note
1. When removing/installing the ABS HU/CM from/to the vehicle, attach a strip of protective tape on the ABS HU/ CM connector to prevent brake fluid from entering.

Brake Pipe Installation Note





1. When installing the brake pipe, align the marks made before removal with the ABS/TCS HU/CM as shown in the figure.

Connector Installation Note





1. Verify that the lock lever of the harness connector is completely pulled up.