Cylinder Head Assembly: Specifications

Cylinder Head





Tightening procedure
(1) 3 - 11 Nm (30.6 - 112 kgf-cm, 26.6 - 97.3 inch lbs.)
(2) 13 - 17 Nm (1.4 - 1.7 kgf-m, 9.6 - 12.5 ft. lbs.)
(3) 43 - 47 Nm (4.4 - 4.7 kgf-m, 31.8 - 34.6 ft. lbs.)
(4) 88° - 92°
(5) 88° - 92°

Cylinder head bolt length
Standard 144.7 - 145.3 mm (5.700 - 5.720 inch)
Maximum: 146 mm (5.748 inch)

Camshaft Bearing Cap





Install the camshaft caps and temporarily tighten the camshaft cap bolts evenly in two or three passes, and then tighten the camshaft cap bolts using the following two steps, in the order shown in the figure.
Tightening procedure
(1) 5.0 - 9.0 Nm (51.0 - 91.7 kgf-cm, 44.3 - 79.6 inch lbs.)
(2) 14.0 - 17.0 Nm (1.5 - 1.7 kgf-m, 10.4 - 12.5 ft. lbs.)

Intake Manifold Specifications

Camshaft Gear/Sprocket Specifications