[2WD]

REAR ABS WHEEL-SPEED SENSOR INSPECTION [2WD]

Installation Visual Inspection
1. Inspect the following items:
^ If there is any malfunction, replace the applicable part.
(1) Excessive play of the ABS wheel-speed sensor
(2) Deformation of the ABS wheel-speed sensor

Clearance Inspection





1. Remove the rear ABS wheel-speed sensor.
2. Measure the distance between the rear ABS wheel-speed sensor installation surface and the ABS sensor rotor. This is dimension A.
3. Calculate the clearance between the front ABS wheel-speed sensor and the ABS sensor rotor using the following formula: Clearance (mm (in)) = A-15.0
4. Verify that the clearance between the ABS sensor rotor and the rear ABS wheel-speed sensor is as indicated below.
^ If there is any malfunction, replace it.

Clearance
^ 0.3 - 1.1 mm (0.012 - 0.043 in)

Sensor Output Value Inspection





1. Turn the ignition switch off.
2. Connect the M-MDS to the DLC-2.
3. Select the following PIDs using the M-MDS:
^ WSPD LR (LR ABS wheel-speed sensor)
^ WSPD RR (RR ABS wheel-speed sensor)
4. Start the engine and drive the vehicle.
5. Verify that the display of the M-MDS shows the same value as the speedometer.
^ If there is any malfunction, replace the rear ABS wheel-speed sensor.