Operation CHARM: Car repair manuals for everyone.
Home >> Mazda >> 2008 >> CX-7 AWD L4-2.3L Turbo >> Repair and Diagnosis >> Body and Frame >> Auxiliary Step / Running Board >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la
If it fails: lemon-manuals.org.ua

Or, hide this message: temporarily or permanently

Auxiliary Step / Running Board: Service and Repair

SIDE STEP MOLDING REMOVAL/INSTALLATION

Removal






1. Remove the fastener.
2. Pull the side step molding front and remove clip A from the vehicle body.
3. Slide the side step molding front to the vehicle front and remove clip B from the side step molding front.
4. Remove the side step molding front.
5. Remove clips B from the body, then install it to the side step molding front.






6. Pull the side step molding front and remove clip C and F from the vehicle body.
7. Detach clip D using a tape-wrapped flathead screwdriver as shown in the figure.
8. Slide the side step molding to the vehicle rear and remove clips E from the side step molding.
9. Remove the side step molding.
10. Remove clips E from the body, then install it to the side step molding.

Installation






1. Install the clip A, D
2. Install the clip B.
3. Install the clips C.
4. Install the side step molding.






5. Install the fastener.
6. Install the clip F
7. Install the clip E.
8. Install the front side step molding.
pro multis · About Operation CHARM