Rear Washer Hose

REAR WASHER HOSE REMOVAL/INSTALLATION




1. Disconnect the negative battery cable.
2. Remove the mudguard (RH).
3. Disconnect rear washer hose A from the washer tank.
4. Remove rear washer hose A from clip A.
5. Disconnect joint pipe A and remove rear washer hose A.

6. Remove the following parts:
1. Console panel
2. Console
3. Front scuff plate inner
4. Front side trim
5. Dashboard under cover
6. Glove compartment
7. Hood release lever
8. Lower panel
9. Center panel
10. Audio unit
11. Climate control unit
12. Knee bolster
13. Meter hood
14. Column cover
15. Instrument cluster
16. Driver-side air bag module
17. Steering wheel
18. Combination switch
19. Steering shaft
20. A-pillar lower trim
21. A-pillartrim
22. Dashboard

7. Disconnect joint pipe B and remove rear washer hose B.
8. Disconnect joint pipe C and remove rear washer hose C.
9. Remove rear washer hose C from clips B.
10. Disconnect joint pipe D and remove rear washer hose C.
11. Detach clips B.
12. Remove the following parts:
1. Rear scuff plate inner
2. B-pillar lower trim
3. Front seat belt upper anchor installation bolt
4. B-pillar upper trim
5. Rear seat
6. Sub trunk box
7. Trunk end trim
8. Trunk side trim
9. C-pillartrim
10. D-pillartrim
11. Map light
12. Sunvisor
13. Assist handle




13. Disconnect joint pipe E.
14. Remove the headliner.
15. Remove rear washer hose D from clips C and D.
16. Cut the urethane of the headliner and remove the tape and rear washer hose D.

NOTE: After installing the rear washer hose, reinforce the urethane that was cut when removing.

17. Remove rear washer hose E from the rear washer nozzle.
18. Install in the reverse order of removal.