Overhaul

ENGINE DISASSEMBLY/ASSEMBLY [MZI-3.7]

1. Remove the transaxle from the engine.
2. Remove the drive plate.
3. Remove the ignition coils.
4. Remove the CMP sensor.
5. Remove the power steering oil pump.
6. Remove the generator.
7. Remove the fuel injector and fuel distributor.
8. Remove the intake-air system.
9. Remove the exhaust system.
10. Remove the thermostat case and water hose component.
11. Remove the CHT sensor.
12. Remove the CKP sensor.
13. Remove the oil pressure switch. (See OIL PRESSURE INSPECTION [MZI-3.7].) Testing and Inspection
14. Remove the oil cooler.
15. Disassemble in the order indicated in the table.
16. Assemble in the reverse order of disassembly.





No.3 Engine Mount Stay (Engine Front Cover Side) Installation Note
1. Tighten the No.3 engine mount stay (engine front cover side) in the order shown in the figure.





Tightening torque
21.6-30.4 N-m (2.21-3.09 kgf-m, 16.0-22.4 ft-lbf)

Water Inlet Pipe Installation Note
1. Apply clean engine coolant to the O-ring.