Torque Specifications
Cylinder HeadNote
^ The cylinder head bolts must be replaced with new bolts. The bolts are torque-to-yield designed and cannot be reused.
Tightening torque
Tighten the cylinder head bolts in the order in 6 steps in the order shown in the figure.
RH bank camshaft caps
Temporarily tighten the camshaft cap bolts evenly in the order shown in several passes.
Tightening torque 8.5-11.5 N-m (87-117 kgf-cm, 76-101 in-lbf)
LH bank camshaft caps
Temporarily tighten the camshaft cap bolts evenly in the order shown in several passes.
Tightening torque 8.5-11.5 N-m (87-117 kgf-cm, 76-101 in-lbf)
Oil Pump
Tighten to 8.5-11.5 N-m (87-117 kgf-cm, 76-101 in-lbf)
Crankshaft Pulley
Tighten the new crankshaft pulley lock bolt in 4 steps.
Tighten to 140 N-m (14 kgf-m, 103 ft-lbf).
Loosen 360° (one full turn) in reverse order.
Tighten to 47-53 N-m (4.8-5.4 kgf-m, 3539 ft-lbf).
Tighten 85°-95°.
Exhaust Manifold
RH Tighten to 22-28 N-m (2.3-2.8 kgf-m, 17-20 ft-lbf)
LH Tighten to 22-28 N-m (2.3-2.8 kgf-m, 17-20 ft-lbf)
Water Pump
Tighten the water pump bolts in the order shown in the figure.
Tighten to 8.5-11.5 14.m (87-117 kgf-cm, 76-101 in-lbf)