Fluid Pressure Sensor/Switch: Service and Repair

OIL PRESSURE SWITCH REMOVAL/INSTALLATION [FS5A-EL]

WARNING:
- When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing ATF.

1. Remove the battery duct and battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the under cover.

4. Disconnect the cord assembly connector.






5. Remove the oil pressure switch.

6. Install the oil pressure switch.

Tightening torque
- 17.1-22.1Nm {1.75-2.25 kgf-m, 13-16 ft-lbf}

7. Connect the oil pressure switch connector.

8. Install the under cover.

9. Connect the negative battery cable.

10. Install the battery duct and battery cover. Removal and Replacement