Assembly Procedure

Assembly procedure





1. Install the tubular pins into the solenoid control valve body.

Caution: Do not confuse gaskets C and D.





2. Set the new gasket C, separator plate, and new gasket D on the solenoid control valve body.
3. Install the pressure modifier accumulator and pressure modifier accumulator spring into the main control valve body.

Primary control valve body spring (standard)








4. Install the tubular pins into the main control valve body.





5. Set the main control valve body onto the solenoid control valve body.





6. Set the seal plate on the main control valve body.





7. Set the upper control valve body onto the main control valve body.





8. Hand-tighten the bolts shown in the figure. Each type of bolt has a different letter on its head.
Match the bolt letter with the letter stamped next to its installation hole on the valve body.

Bolts identification








9. Tighten the bolts evenly and gradually in the order shown.

Tightening torque:
7.8-10.8 Nm (80-110 kgf-cm, 69-95.5 in. lbf.)





10. Install the shift solenoid D, E, and pressure control solenoid A.

Tightening torque:
7.8-10.8 Nm (80-110 kgf-cm, 69-95.5 in. lbf.)





11. Install the shift solenoid A, B, C.





12. Install the bracket.

Tightening torque:
7.8-10.8 Nm (80-110 kgf-cm, 69-95.5 in. lbf.)

13. Install the packing.
14. Apply ATF to new O-ring and install it onto the oil strainer.
15. Install the oil strainer onto the main control valve body.