Bearing and Locknut Assembly Note
Bearing and Locknut Assembly Note1. Shift to 1st gear.
2. Install the bearing.
3. Lock the primary shaft using the SST.
4. Tighten the new lock nuts with the bearing onto the primary and secondary shafts.
Tightening torque:
150 - 212 N-m (15.3 - 21.6 kgf-m, 111 - 156 ft-lbf)
5. Stake the locknuts.
6. Measure the 5th gear thrust clearance using a feeler gauge.
^ If it exceeds the maximum specification, reassemble the transaxle.
5th gear thrust clearance
Standard: 0.100 - 0.220 mm (0.0040 - 0.0086 in)
Maximum: 0.270 mm (0.0106 in)
7. Measure the 6th gear thrust clearance using a dial indicator.
^ If it exceeds the maximum specification, reassemble the transaxle.
6th gear thrust clearance
Standard: 0.100 - 0.220 mm (0.0040 - 0.0086 in)
Maximum: 0.270 mm (0.0106 in)