Diagnostic Assist Function [Audio (Standard Audio)]

DIAGNOSTIC ASSIST FUNCTION [AUDIO (STANDARD AUDIO)]

Information Display Inspection

1. With the audio power ON, press the POWER/VOLUME switch and simultaneously press the SEEK switch (up) for approx. 1 s.






2. Inspect according to the following table:






3. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.

Switch Inspection

1. With the audio power ON, press the POWER/VOLUME switch and simultaneously press the CLOCK switch for approx. 1 s.






2. Inspect according to the following table:






3. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.

Speaker Inspection

1. With the audio power ON, press the POWER/VOLUME switch and simultaneously press the AUTO-M switch for approx. 1 s.






2. Inspect according to the following table:






3. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.

Radio Reception Condition Inspection

1. Turn the audio unit power to ON.

2. Tune in the radio.

3. While pressing the POWER/VOLUME switch, simultaneously press the PRESET switch 2 for approx. 1 s.






4. Inspect according to the following table:

CAUTION:
- Even if the system is normal, radio reception may be difficult depending on where the system is inspected (indoors/outdoors, or conditions at the location). Before inspecting the system, verify that radio reception is adequate.
- When inspecting, select a frequency band (radio station) with the best reception.





5. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.

Antenna control condition inspection

1. With the audio power on and at radio mode, press the POWER/VOLUME switch and simultaneously press the SAT switch for approx. 1 s.






2. Inspect the antenna control condition according to the following table:






3. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.

Audio Amplifier Specification Inspection

1. With the audio power ON, press the POWER/VOLUME switch and simultaneously press the SEEK switch (down) for approx. 3 s.






2. Inspect according to the following table:






3. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.

SIRIUS Software Version Verification

1. Turn the audio unit power to ON.

2. Tune in the SIRIUS satellite radio.

3. With the audio power ON, press the POWER/VOLUME switch and simultaneously press the PRESET switch 1 and PRESET switch 3 for approx. 3 s.






4. Inspect according to the following table:






5. Turn the audio OFF or the ignition switch to the LOCK position to stop the diagnostic assist function.