Radiator Cooling Fan Motor: Testing and Inspection

FAN MOTOR INSPECTION [MZI-3.7]

Part Inspection

1. Verify that the battery is fully charged. Testing and Inspection

2. Disconnect the cooling fan motor connector (fan control module side, 2 terminals).

3. Install a tester and battery to the cooling fan motor connector as shown in the figure.






4. Verify that each fan motors operate smoothly at the standard current.

- If there is any malfunction, replace the applicable part.

Cooling fan motor standard current [Single Fan Control Module]
- No.1, No.2: 11.2-15.2 A

Cooling fan motor standard current [Dual Fan Control Module]
- No.1, No.2: 17-23 A