Overhaul

ENGINE DISASSEMBLY/ASSEMBLY [MZI-3.7]

1. Remove the transaxle from the engine. Automatic Transaxle Removal/Installation

2. Remove the drive plate. Service and Repair

3. Remove the ignition coils. Service and Repair

4. Remove the CMP sensor. Service and Repair

5. Remove the power steering oil pump. Removal and Replacement

6. Remove the generator. Removal and Replacement

7. Remove the fuel injector and fuel distributor. Service and Repair

8. Remove the intake-air system. Service and Repair

9. Remove the exhaust system. Service and Repair

10. Remove the thermostat case and water hose component. Service and Repair

11. Remove the CHT sensor. Service and Repair

12. Remove the CKP sensor. Service and Repair

13. Remove the oil pressure switch. Testing and Inspection

14. Remove the oil cooler. Service and Repair

15. Disassemble in the order indicated in the table.

16. Assemble in the reverse order of disassembly.










No.3 Engine Mount Stay (Engine Front Cover Side) Installation Note

1. Tighten the No.3 engine mount stay (engine front cover side) in the order shown in the figure.






Tightening torque
- 21.6-30.4 Nm {2.21-3.09 kgf-m, 16.0-22.4 ft-lbf}

Water Inlet Pipe Installation Note

1. Apply clean engine coolant to the O-ring.