Input/Turbine Speed Sensor Removal/Installation

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]

WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until then are cool before replacing the ATF.

1. Disconnect the negative battery cable.

2. Remove the air cleaner component. Service and Repair

3. Drain the ATF. Automatic Transaxle Fluid (ATF) Replacement

4. Remove the oil cooler.






5. Remove the oil pipe. Removal and Replacement

6. Remove the control valve body. Removal and Replacement

CAUTION:
- Do not damage the input/turbine speed sensor.

7. Remove the input/turbine speed sensor.






8. Install the input/turbine speed sensor.

Tightening torque
- 3.9-6.9 Nm {40-70 kgf-cm, 26-60 in-lbf}

9. Install the control valve body. Removal and Replacement

10. Install the oil pipe. Removal and Replacement

11. Install the oil cooler. Removal and Replacement

12. Add ATF to the specified level. Automatic Transaxle Fluid (ATF) Replacement

13. Install the air cleaner component. Service and Repair

14. Connect the negative battery cable.

15. Perform the mechanical system test. Mechanical System Test